Otto Frei 4-1/2" Bent Nose Prong Pulling Pliers-German Made Chains Repeat on both sides of

Repeat on both sides of each drawn line until flutes are roughed out across the full surface of the project

1 piece – 14K Yellow Gold Hard Flow solder (~1/3 DWT)

643 Dual Handpiece Rest (MAAH-HR) Holds 2 flex shaft handpieces

Permanent magnet DC motor delivers high torque at all speeds — from low RPM through full 15

Otto Frei 4-1/2" Bent Nose Prong Pulling Pliers-German Made Chains Repeat on both sides ofThe Otto Frei 4 1 2" Bent Nose Prong Pulling Pliers are a modified chain nose design engineered specifically for controlled prong lifting. The lower jaw is grooved to cradle and support the prong during the lift, while the upper jaw is slightly cut back and hooked to catch securely under the tip of the prong as it rests against the stone. This geometry gives the setter precise, repeatable leverage with reduced risk of marring the prong or stone.